3. Double screw fixation:
This crown have a double fixation system with two screws to fix better in axle, we are thinking in endurance races.
4. Variable motor axle width:
This crown is made in 3 diferent parts, the axle wall have two diferent position for 5.5mm pinion, and for 6.0mm pinions. With this two positions is posible adjust the crown for each pinion with only change the axle wall position.
Its simple, sice today, the slot pinions have increase the number of tooths but never increase the diameter of pinion, this solution is not a very good solution becouse that solution incompatibilice the crown and pinion. Normally when the pinion increase tooths is normally increase the diamenter like slot cars in sidewinder.
5. Adjusting inertia:
With this design we can change the material of axle wall to adjust the inertia of the car, and this increase or decrase the breaking distance. We will offer in a future diferent axle walls in diferent weigth to adjust this parameter.
6. Spare parts of crown:
Since today when a screw break the crown you need change all crown, now with this design you only need change the pressor system.
7. Compatible with 3/32" Slot Axle:
The most used axle in 1:32 slot cars is 3/32", and this crown is adapted to axle perfectly.
8. Now in 25T:
We think this is the perfect measure for endurance races, and we prefer begin with this tooths becouase we can offer a very good product better that our competitors.